Power Tool HelpCategory
Recently, Husqvarna released several outstanding videos explaining how get started with Husqvarna trimmer and we wanted to share them with you. In the following 5-part series you will learn how to properly assemble, fuel, start and maintain your Husqvarna trimmer. Enjoy!
Fuel and Lubricati..
How to Adjust a 2 cycle carb:
*HOW TO ADJUST A 2-CYCLE CARBURETOR*
a. There are two screws on the carb — one for idle and one for high speed. (These are typically noted with symbols H (High) and L (Low). There is also a third screw to determine how fast you want the unit to idle once the carb is adjusted know..
How-to start your Chainsaw
Now that the bar and chain are on the unit and the chain is tensioned correctly you are ready to start the unit. (If you have not yet assembled your saw please go here for instructions!)
- Fill the unit with the proper oil and gas mixture. Be sure not to use old gas or E85 and as a gen..
How-to assemble your Chainsaw
*Please Note: These are general instructions that apply to most units, please consult your manual or the manufacturer for model specific instructions that may differ from this if you have additional questions or concerns!
- Check that the chain brake is in disengaged pos..
Did your Husqvarna’s chain brake get stuck while you were trying to install the bar and the chain? Can’t get the clutch cover back on? If you were searching for how to reset the chain brake after its locked out, look no further. After reading this post (or watching the video) you will learn how to disengage and re..